Cisco ONS 15454 SDH Configuration Manual page 548

show rpr-ieee protection
show rpr-ieee protection
Use this command to display the protection state of the local station, along with brief overview of the
station's neighbors, timer configuration, and self-detected failures that might contribute to the current
state.
Syntax Description
This command has no arguments or keywords.
Defaults N/A
Command Modes Privileged exec
Usage Guidelines
Use this command to show the current protection status on the ring.
In this command, protection can be shortened to prot.
Examples
router# show rpr-ieee protection
Protection Information for Interface RPR-IEEE0
MAC Addresses
West Span (Ringlet 0 RX) neighbor 000b.fcff.9d34
East Span (Ringlet 1 RX) neighbor 0013.1991.1fc0
Station MAC address 0005.9a3c.59c0
TP frame sending timers:
fast timer: 10 msec
Protection holdoff timers:
Configured protection mode: STEERING
Protection Status
Ring is IDLE
Protection WTR period is 10 sec. (timer is inactive)
West Span Failures: none
East Span Failures: none
Related Commands None
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
A-72
slow timer: 1x100 msec (100 msec)
L1 Holdoff
West Span 0x10 msec (
East Span 0x10 msec (
Self Detected Requests
West Span IDLE
East Span IDLE
Distant Requests
East Span IDLE
Keepalive Detection
0 msec) West Span
0 msec) East Span
Remote Requests
West Span IDLE
East Span IDLE
West Span IDLE
Appendix A Command Reference
5 msec
5 msec