Cisco ONS 15454 SDH Configuration Manual page 557

Appendix A Command Reference
[no] spr load-balance {auto | port-based}
Use this command to specify the Cisco proprietary RPR load-balancing scheme for unicast packets.
Syntax Description Parameter
auto
port-based
Defaults
The default setting is auto.
Command Modes
SPR interface configuration
Examples The following example configures an SPR interface to use port-based load balancing:
Router(config)# interface spr 1
Router(config-if)# spr load-balance port-based
Related Commands
interface spr 1
Description
The default auto option balances the load based on the MAC addresses
or source and destination addresses of the IP packet.
The port-based load balancing option maps even ports to the POS 0
interface and odd ports to the POS 1 interface.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
[no] spr load-balance {auto | port-based}
A-81