Cisco ONS 15454 SDH Configuration Manual page 501

Appendix A Command Reference
[no] rpr-ieee report alarm
Use this command to specify which IEEE 802.17b based RPR alarms or signals are logged to the
console. Use the no form of the command to disable a particular type of notification.
Syntax Description Parameter
alarm
Defaults N/A
Command Modes
IEEE 802.17b based RPR interface configuration
Usage Guidelines
This command does not determine whether alarms are reported to the TCC2P or whether they are shown
in CTC. Conditions that are reported to the CLI console as a result of this command are soaked and
cleared per Telcordia GR-253-CORE. Use the no form of the command to disable reporting of a specific
alarm/signal.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee report all
Related Commands None
Description
The SONET/SDH object that is logged to the console. The alarms are as
follows:
all—All link down alarm and signal failures
encap—Path signal label encapsulation mismatch failure
pais—Path alarm indication signal failure
plop—Path loss of pointer failure
ppdi—Path payload defect indication failure
pplm—Payload label mismatch path
prdi—Path remote defect indication failure
ptim—Path trace indicator mismatch failure
puneq—Path label equivalent to zero failure
sd-ber-b3—PBIP BER in excess of SD threshold failure
sf-ber-b3—PBIP BER in excess of SF threshold failure
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
[no] rpr-ieee report alarm
A-25