Cisco ONS 15454 SDH Configuration Manual page 503

Appendix A Command Reference
[no] rpr-ieee ri {primary | secondary} delay interval
Use this command to change the soak time for a primary card in active mode. Use the no form of this
command to set the timer to default.
Syntax Description Parameter
primary
secondary
interval
Command Default
The default is 3,000 milliseconds.
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines None.
Examples In this example, interface is shortened to int.
router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee ri primary delay 1000
Related Commands rpr-ieee ri mode {primary | secondary}
Description
Single traffic queue mode.
Dual traffic queue mode.
Interval that the active mode timer waits before switching to the secondary
card. Range is 1,000 to 20,000 milliseconds.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
[no] rpr-ieee ri {primary | secondary} delay interval
A-27