Rip; Eigrp; Ospf; C H A P T E R 11 Configuring Networking Protocols - Cisco ONS 15454 SDH Configuration Manual

RIP

RIP
To configure the Routing Information Protocol (RIP), perform the following procedure, beginning in
global configuration mode:
Command
Step 1
Router(config)# router rip
Step 2
Router(config-router)# network
net-number
Step 3
Router(config-router)# exit

EIGRP

To configure the Enhanced Interior Gateway Routing Protocol (EIGRP), perform the following
procedure, beginning in global configuration mode:
Command
Step 1
Router(config)# router eigrp
autonomous-system-number
Step 2
Router(config-router)# network
net-number
Step 3
Router(config-router)# exit

OSPF

To configure the Open Shortest Path First (OSPF) protocol, perform the following procedure, beginning
in global configuration mode:
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
11-2
Chapter 11 Configuring Networking Protocols
Purpose
Enters router configuration mode, defines RIP as the
routing protocol, and starts the RIP routing process.
Specifies a directly connected network based on the
Internet Network Information Center (InterNIC) network
number—not a subnet number or individual address. The
routing process associates interfaces with the appropriate
addresses and begins processing packets on the specified
network.
Returns to global configuration mode.
Purpose
Defines EIGRP as the IP routing protocol.
The autonomous system number is the
autonomous system to which this ML-Series card
belongs.
Defines the directly connected networks that run
EIGRP.
The network number is the number of the network
that is advertised by this ML-Series card.
Returns to global configuration mode.