Displaying Rmon Status - Cisco ONS 15454 SDH Configuration Manual

Displaying RMON Status

ML_Series(config)# show interface pos 0
POS0 is up, line protocol is up
Hardware is Packet/Ethernet over Sonet, address is 0005.9a39.713e (bia 0005.9a39.713e)
MTU 1500 bytes, BW 48384 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 182/255
Encapsulation: Cisco-EoS-LEX, crc 32, loopback not set
Keepalive set (10 sec)
Scramble enabled
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 34621000 bits/sec, 60083 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
311190527 packets input, 931220183 bytes
Received 0 broadcasts (0 IP multicast)
6 runts, 0 giants, 0 throttles
0 parity
6 input errors, 6 CRC, 0 frame, 0 overrun, 0 ignored
Displaying RMON Status
RMON status commands do not work for POS interfaces.
Note
To display the RMON status, use one or more of the privileged EXEC commands in
Table 21-3
Command
show rmon
show rmon alarms
show rmon events
show rmon history
show rmon statistics
Example 21-1
Example 21-1 CRC Errors Displayed with show rmon Commands
ML_Series# show rmon alarms
Alarm 9 is active, owned by config
Monitors ifInErrors.983043 every 300 second(s)
Taking delta samples, last value was 0
Rising threshold is 1000, assigned to event 10
Falling threshold is 1000, assigned to event 10
On startup enable rising or falling alarm
ML_Series# show rmon events
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
21-20
Commands for Displaying RMON Status
Purpose
Displays general RMON statistics.
Displays the RMON alarm table.
Displays the RMON event table.
Displays the RMON history table.
Displays the RMON statistics table.
shows examples of the commands in
Chapter 21 Configuring RMON
Table 21-3.
Table 21-3.