G-Series Gigabit Ethernet Transponder Mode; Figure 23-5 G-Series Manual Cross-Connects - Cisco ONS 15454 SDH Configuration Manual

G-Series Gigabit Ethernet Transponder Mode

In this section, "cross-connect" and "circuit" have the following meanings: Cross-connect refers to the
Note
connections that occur within a single ONS node to allow a circuit to enter and exit an ONS node. Circuit
refers to the series of connections from a traffic source (where traffic enters the ONS node network) to
the drop or destination (where traffic exits an ONS node network).
Figure 23-5
G-Series Gigabit Ethernet Transponder Mode
The ONS 15454 and ONS 15454 SDH G-Series cards can be configured as transponders. Transponder
mode can be used with any G-Series-supported GBIC (SX, LX, ZX, coarse wavelength division
multiplexing [CWDM], or dense wavelength division multiplexing [DWDM]).
level overview of a transponder mode application.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
23-8
G-Series Manual Cross-Connects
Non-ONS
Network
ONS Node
Chapter 23 E-Series and G-Series Ethernet Operation
ONS Node
SONET/SDH
Ethernet
Figure 23-6 shows a card