Appendix A Command Reference
microcode fail system-reload
In the event of a microcode failure, use this command to configure the ML-Series card to save
information to the flash memory and then reboot. The information is saved for use by the Cisco Technical
Assistance Center (Cisco TAC). To contact TAC, see the
Service Request" section on page
Defaults
N/A
Command Modes
Global configuration
Usage Guidelines
This command and feature is specific to ML-Series card.
Examples
router(config)# microcode fail system-reload
Related Commands
N/A
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
"Obtaining Documentation and Submitting a
xxxviii.
microcode fail system-reload
A-7