Rip Authentication - Cisco ONS 15454 SDH Configuration Manual

Chapter 11 Configuring Networking Protocols
Command
Step 13
Router# show ip protocols
Step 14
Router# copy running-config
startup-config
To turn off the RIP routing process, use the no router rip global configuration command.
To display the parameters and current state of the active routing protocol process, use the show ip
protocols privileged EXEC command
Example 11-2 show ip protocols Command Output (Showing RIP Processes)
Router# show ip protocols
Routing Protocol is "rip"
Sending updates every 30 seconds, next due in 15 seconds
Invalid after 180 seconds, hold down 180, flushed after 240
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Redistributing: rip
Default version control: send version 1, receive any version
Automatic network summarization is in effect
Maximum path: 4
Routing for Networks:
Routing Information Sources:
Distance: (default is 120)
Use the show ip rip database privileged EXEC command to display summary address entries in the RIP
database
Example 11-3 show ip rip database Command Output
Router# show ip rip database
192.168.1.0/24
192.168.1.0/24
192.168.2.0/24
192.168.2.0/24
192.168.3.0/24
192.168.3.0/24

RIP Authentication

RIP Version 1 does not support authentication. If you are sending and receiving RIP Version 2 packets,
you can enable RIP authentication on an interface. The key chain determines the set of keys that can be
used on the interface. If a key chain is not configured, no authentication is performed, not even the
default.
The switch supports two modes of authentication on interfaces for which RIP authentication is enabled:
plain text and message-digest key (MD5). The default is plain text.
Purpose
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Interface Send
FastEthernet0 1
POS0 1
192.168.2.0
192.168.3.0
Gateway Distance
192.168.2.1 120
(Example 11-3).
auto-summary
[1] via 192.168.2.1, 00:00:24, POS0
auto-summary
directly connected, POS0
auto-summary
directly connected, FastEthernet0
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
(Example 11-2).
Recv Triggered RIP Key-chain
1 2
1 2
Last Update
00:00:23
Configuring RIP
11-7