Ml-Series Ios Cli Console Port; Figure 3-2 Ctc Node View Showing Ip Address And Slot Number; Telnetting To A Management Port - Cisco ONS 15454 SDH Configuration Manual

Telnetting to a Management Port

Figure 3-2
Step 3 Use the IP address and the total of the slot number plus 2000 as the Telnet address in your preferred
communication program. For example, for an IP address of 10.92.57.187 and Slot 13, you would enter
or telnet
Telnetting to a Management Port
Users can access the ML-Series through a standard Cisco IOS management port in the same manner as
other Cisco IOS platforms. For further details about configuring ports and lines for management access,
refer to the Cisco IOS Configuration Fundamentals Configuration Guide.
As a security measure, the vty lines used for Telnet access are not fully configured. In order to gain
Telnet access to the ML-Series card, you must configure the vty lines via the serial console connection
or preload a startup-configuration file that configures the vty lines. A port on the ML-Series must first
be configured as the management port; see the

ML-Series IOS CLI Console Port

The ML-Series card has an RJ-11 serial console port on the card faceplate labeled CONSOLE. The
console port is wired as data circuit-terminating equipment (DCE). It enables communication from the
serial port of a PC or workstation running terminal emulation software to the Cisco IOS CLI on a specific
ML-Series card.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
3-4
CTC Node View Showing IP Address and Slot Number
.
10.92.57.187 2013
"Configuring the Management Port" section on page
Chapter 3 Initial Configuration
3-8.