2. Monitor Screens
2.5.2 Canceling the Machine Position Trace
Operation method
(1) Start tracing with the machine position.
(2) Press the main menu Trace ON .
2.5.3 Displaying the Tool Center Point Trace
Operation method
(1) Press the main menu Tip TraceON .
2.5.4 Canceling the Tool Center Point Trace
Operation method
(1) Start tracing with the tool center point.
(2) Press the main menu Tip TraceON .
•
The Trace ON menu is unhighlighted.
•
The tool mark in the drawing area is erased.
•
The message "Tracing" is erased.
The Tip TraceON menu is highlighted.
•
If Trace ON is highlighted, unhighlight it.
The tool center point appears in the drawing area as a tool
•
mark.
•
The tool center position is displayed at the counter.
The message "Tracing Tip Position" appears.
•
After this, the tool center point path is drawn with graphics in
the tool center point trace mode.
(Note) If graphic check (2D) is executed, the "Tip Trace ON"
status is cancelled.
The Tip TraceON menu is unhighlighted.
•
•
The tool mark in the drawing area is erased.
•
The message "Tracing Tip Position" is erased.
41
2.5 Trace