Mitsubishi Electric 700 Series Training Manual page 129

3. Setup Screen
Menus (L system)
Menu
This displays the data of a group when that group No. of tool life
Group
management data is set and the
No.
No. can be referred to in the group list.
Copies one line of tool life management data where the cursor is
Line
copy located.
The copied tool life management data is written to the data in the line
where the cursor is located.
If the copied data is changed after the menu key Line copy
Line
paste
is pressed, the data before changing is written when pasted.
The copied data can be pasted as many times as is required until new
data is copied.
This erases a designated line (multiple lines possible) of tool life
management data.
The first line No. and the last line No. of the data to be erased is
Line
clear specified with a " / " separating the Nos.
If the INPUT key is pressed without specifying a line, the data in
the line where the cursor is located is erased.
This changes a group No.
If a new group No. is specified and the INPUT key pressed, the
Grp No.
change
group No. changes.
An error occurs if a pre-existing group No. is set.
The group active area is changed if parameter " #1107 Tllfsc " is set to
Group
1 or 2.
change
Changes to the multiple group life management data display mode
Multi
based on the parameter " #1107 Tllfsc " setting value.
group
This creates a new group and displays the life management data
Group
containing no data.
regist
This displays the list of tool life data groups.
Group
list
The multiple group life management data display mode is cancelled.
Close
Operation method (Designating a group No.) (L system)
(1) Press the
Group No.
(2) Designate the group No. to be displayed.
12 INPUT
If a group No. that does not exist is set, a message appears to confirm the creation of a new No..
(Note)
A new group is created if Y or INPUT is pressed.
When creating a new group, set the method and life data at the end of the group No., separating
the data with a " / " . If the method and life data are omitted, a new group is created with method =
0 (usage time), and life data = 0.
Details
INPUT key is pressed. The group
menu.
121
3.5 Tool Life Management
The menu is highlighted.
The tool life data of the designated group No. appears, and
the cursor moves to the head of the data.
Type Reference
A "Designating a group
No."
C "Copying/pasting the
tool life data"
B
A "Erasing one line of tool
life management data"
"Designating and
erasing a line"
A "Changing a group No."
C "Changing the active
area for multiple group
displays"
C
A "Registering a group"
C
C