Mitsubishi Electric 700 Series Training Manual page 92

3. Setup Screen
Menus
Menu
This sets the tool compensation amount.
There are three types of tool compensation, and the display differs for each
type.
The number of tool compensation combinations set/displayed differs depending
on the options.
This performs the tool measurement.
By manually moving the tool to the measurement point, the movement distance
from the basic point to the measurement point is measured, and this can be set
as the tool compensation amount.
This menu displays if the option is enabled.
This registers tools.
A tool number is allocated to the tool to allow the NC to recognize the tool
attached to the machine. The tool number is registered based on the magazine
pot, spindle, and standby location to which the tool is attached.
This performs the tool life management.
The life management data containing information such as the tool usage status
is set and displayed.
Two management methods are used for tool life management.
This menu displays if the option is enabled.
This sets the workpiece coordinate system offset amount.
This sets and displays the coordinate system offset amount controlled by the
NC.
This performs the workpiece measurement.
This menu displays if the option is enabled.
This sets the user parameters.
This screen is used to switch between, set, and display eleven different
parameter types.
This edits the MDI program.
Press this menu to show the MDI program contents in a pop-up display.
This sets an arbitrary value for the relative position counter.
This performs the manual numerical value commands.
This searches T code among the designated program (including the
subprograms) and lists in order that it was found. This menu is displayed only
when the T code list option is valid.
This registers machining programs to the pallet of automatic pallet changer
(hereinafter APC). This menu displays if the option is enabled.
Details
84
3.1 Screen Configuration
Reference
3.2 Tool Compensation
amount
3.3 Tool Measurement
3.4 Tool Registration
3.5 Tool Life
Management
3.6 Workpiece
Coordinate System
Offset
3.7 Workpiece
Measurement
3.8 User Parameters
3.9 MDI Program Editing
3.10 Counter Setting
3.11 Manual Numerical
Value Commands
3.12 T Code List
3.13 Pallet Program
Registration