Erasing The Coordinate System Offset Amount; Setting The Workpiece Coordinate Origin - Mitsubishi Electric 700 Series Training Manual

3. Setup Screen

3.6.2 Erasing the Coordinate System Offset Amount

Operation method (Erasing the coordinate system (excluding G92) offset amount where the cursor is
displayed for all axes.)
(1) Press the menu
(2) Press the
Y key.
Operation method (Erasing all axis offset data of all coordinate systems (excluding G92 and EXT))
(1) Press the menu
(2) Press the
Y key.
(Note) G92 data cannot be erased.

3.6.3 Setting the Workpiece Coordinate Origin

Press the menu Simple settings key to set the coordinate system offset so that the current machine
position (for all axes) becomes the workpiece coordinate origin. It is only possible to set those axes where the
cursor is located.
(Note) When the menu Easy setting is pressed for an axis, the local offset (G52) data of the axis will
be also erased.
All axs clear menu.
All clear menu.
3.6 Workpiece Coordinate System Offset
The menu is highlighted.
A message displays confirming whether it is okay to erase
the data.
All of the coordinate system indicated by the cursor is
cleared to zero.
In addition, all axes data of the local offset (G52) for the
coordinate system will be erased.
The menu is highlighted.
A message displays confirming whether it is okay to erase
the data.
All coordinate system data is erased.
In addition, all axes data of the local offset (G52) for the G54
to G59 coordinate systems will be erased.
128