Copying/Pasting Parameters - Mitsubishi Electric 700 Series Training Manual

6. Maintenance Screens

6.1.3 Copying/Pasting Parameters

Designating the cursor position and copying
(1) Move the cursor to the parameter to be
copied.
(2) Press the menu
INPUT .
(Note) When the screen has an array structure for each axis or each part system, an error will occur if
different rows (axis or part system) are designated for the copy start position and end position.
Copying by designating the parameter No. with key inputs
(1) Move the cursor to the display area of the
axes or part system to be copied.
(2) Press the menu
(3) Designate the copy range.
Format: First No./Last No.
8203/8205
If the last No. to be copied is the last No. of
the currently displayed parameter type, "E"
can be designated. (Example) 8201/E
If only one parameter is being copied,
input only the No. of the parameter to
copy, and then press the INPUT key.
Pasting the copied data
(1) Move the cursor to the display area of the
axes or part system where the data will be
pasted.
(2) Press the menu key Area paste .
(3) Press Y or
The copied data will not be written in when
the N key is pressed.
Area copy and
Area copy .
INPUT
INPUT .
The menu is highlighted.
The setting value of the parameter at the cursor position
highlighted.
The menu is highlighted.
The copy target range is highlighted.
The menu highlight returns to normal.
The menu is highlighted, and a message confirming the
operation appears.
The copied data is written to the parameter with the same
number as when copied, in the area where the cursor is.
The menu highlight returns to normal.
237
6.1 Parameter Screens