Mitsubishi Electric 700 Series Training Manual page 196

4. Edit Screens
Setting the tool type (Kind)
(1) Use the cursor keys to move the cursor to
the tool type setting column.
(2) Press the tool type menu.
(Ex.) Menu
It is also possible to set input values.
0 INPUT : Default tool
1 INPUT : Ball end mill
2 INPUT : Flat end mill
3 INPUT : Drill
4 INPUT : Bull nose end mill
5 INPUT : Chamfer
6 INPUT : Tap
(Note) The drill appears in the guide drawing area when the default tool is designated.
Tool type guide drawing
1: Ball end mill
4: Bull nose end mill
Ball endmill
" Ball endmill " appears at the cursor position.
The cursor moves one place to the right.
The ball end mill guide drawing (note) appears in the guide
drawing area.
2: Flat end mill
5: Chamfer
188
4.4 Program Check (3D)
3: Drill
6: Tap