Mitsubishi Electric 700 Series Training Manual page 140

3. Setup Screen
Menus
Menu
The results calculated from the measurement counter are set in the
displayed workpiece coordinate system offset.
Only the axis for which a value is displayed in the measurement
Coord
counter can be set.
write
(Note) If the workpiece coordinate system to be set is G54 to G59,
the local coordinate system offset value will be zero. (Only for
the measured axis.)
This selects the displayed workpiece coordinate system from the
sub-menu (G54 - G59). Select the workpiece coordinate system to
Coord
display the selected workpiece coordinate system offset in the
G54-G59
coordinate system offset section.
(Perform the offset amount setting at the menu
Input the P number to display the selected extension workpiece
coordinate system (G54.1 Pn) offset in the coordinate system offset
section.
Coord
G54.1 P
(Perform the offset amount setting at the menu
This menu does not display if the extension workpiece coordinate
system offset option is disabled.
This displays the external workpiece coordinate system offset in the
Coord
coordinate system offset section.
EXT
(Perform this setting at the menu
This creates a false signal when performing simple measurement
(measurement without using the touch sensor) and reads the skip
SkipPos
position. Press this menu to display the measurement position
take in
measured from the machine position of the axis moved last (axis 1 or
2) at the measurement counter.
This enables surface measurement.
Face
Surface measurement is possible when the power is turned ON.
meas
This enables hole measurement. (The cursor moves to the
Hole
meas measurement counter point A.)
This enables width measurement. (The cursor moves to the
Width
measurement counter point A.)
meas
This enables rotation measurement. (The cursor moves to the
Rotate
measurement counter point A.)
meas
This changes the axes displayed at the coordinate system offset and
Next
measurement position counter from axis 1 - 5, and axis 6 and over.
axis
(Note) This displays when the number of enabled axes is 6 or over.
This sets the center shift amount. (The cursor moves to the 1st axis of
Center
"center shift (S)" when this is selected.)
shift
This sets the coordinate rotation center. (The cursor moves to the 1st
Rotate
center axis of "coordinate rotation center" when this is selected.)
This sets the coordinate rotation angle. (The cursor moves to the
Rotate
angle "coordinate rotation angle" when this is selected.)
Details
Coord write
Coord write
Coord write key.)
132
3.7 Workpiece Measurement
Type Reference
C
C
key.)
A
key.)
C
B
B 3.7.1 Carrying Out
Surface Measurement
B 3.7.2 Carrying Out Hole
Measurement
B 3.7.3 Carrying Out Width
Measurement
B 3.7.4 Carrying Out
Rotation Measurement
C
A 3.7.4 Carrying Out
Rotation Measurement
A
A