Changing The Display - Mitsubishi Electric 700 Series Training Manual

4. Edit Screens

4.2.7 Changing the Display

Changing the display with the cursor key
The cursor will move up one line in the program each time the cursor key (
If the key is pressed at the top line of the program display area, the program will scroll up one line.
If the key is pressed at the end, the program will scroll down one line.
When a block is displayed over 2 or more lines,
editing and by line unit during mass-editing.
↑
↑
↑
Move the cursor using the tab keys ( | ← : back tab/ → | : tab).
| ← key :
Moves to the start of the word where the cursor is currently positioned.
If the cursor is at the start of a word, it moves to the start of the previous word.
→ | key :
Moves to the word after the word where the cursor is currently positioned.
Cursor destination when |← key
pressed
Cursor destination when |←
key pressed again
(Note) Pressing | ← → | keys or ← → keys does not make any difference in mass-editing.
Split display by word unit
In regular editing, program is split by word unit and displayed.
In mass-editing, program is not split by word unit and displayed as text data.
,
1:N1 G28 X0. Y0. Z0.;
2:N2 G92 X0. Y0. Z0.;
3:N3 G00 X-300.
Y-300. Z-300.;
4:N4 G01 X-200. Y-200.
F2000;
11:N11;
12:N12 Z300.;
13:Y200.;
14:;
Current cursor position
3 N3 G00 X-300. Y-300. Z-300.;
4 N4 G01 X-200. Y-200. F2000;
: :
151
4.2 Program Editing
,
keys move the cursor by block unit during regular
↓
Cursor moves in same
display.
↓
↓
Display scrolls without
moving cursor position.
Cursor destination when →| key
pressed
) is pressed.