Mitsubishi Electric 700 Series Training Manual page 98

3. Setup Screen
Menus
Menu
This executes an absolute input.
= Input
This executes an addition input.
+ Input
This changes to the wear data display.
Wear
data
(Note) This menu displays for Type III.
This changes to the tool length data display.
Length
data
(Note) This menu displays for Type III.
This changes to the tool nose data display.
Nose
data
(Note) This menu displays for Type III.
Set the compensation number and press INPUT to put that
Offset
number to the top and display the tool compensation data.
No.
The cursor moves to the contents of that first line.
This copies the contents of the tool compensation data in the selected
Line
copy line (one line).
The contents (one line) of the copied tool compensation data are
written to the line where the cursor is.
If changes are made to the data in that line after Line copy is
Line
selected from the menu, the data prior to the changes is written when
paste
pasting.
The data in the copied line can be pasted as many times as is
required until new data is copied.
This erases the compensation data in the selected line (multiple lines
can be erased).
Selection method: Select the first and the last compensation number
to be erased.
Line
[Ex.] 1/E: Set all compensation data to " 0 " .
clear
If the INPUT key is pressed without selecting a line, the
compensation data in the line where the cursor is currently positioned
is erased.
This undoes the last changes to the tool compensation data.
Undo
(This menu is valid for the "Data Input", "Paste Line" and "Undo"
operations.)
For Type III, the wear data displays when the power is turned ON.
Following that, the wear data, tool length data, and tool nose data selection is stored.
Details
90
3.2 Tool Compensation Amount
Type
C 3.2.1 Setting the Tool
Compensation Data
C
B
B
B
A 3.2.1 Setting the Tool
Compensation Data
C 3.2.3 Copying/Pasting
the Tool Compensation
Data
C
A 3.2.2 Erasing the Tool
Compensation Data
C
Reference