Mitsubishi Electric 700 Series Training Manual page 192

4. Edit Screens
Setting the material basic point (WokRefPoint (I)) and size (WrkWidth (I,J,K))
Enter the material basic point and size. Specify the material basic point with the machine coordinate.
(1) Use the ↑ , ↓ keys to move the
cursor to the material basic point (I)
setting column.
(2) Input data.
(Ex.) 100 INPUT
(3) Other basic points and width data are set
in the same way.
(Note 1) The workpiece will not be displayed if two or more size data are " 0 " .
(Note 2) The setting range of the material basic point and width is as follows.
#1003
iunit
B
C
D
E
Setting the material color (WorkColor)
(1) Use the ↑ , ↓ keys to move the
cursor to the material color setting
column.
(2) Press the material color menu.
(Ex.) Menu Gray
It is also possible to set input values.
0 INPUT : Default color
1 INPUT : Gray
2 INPUT : Red
3 INPUT : Yellow
4 INPUT : Blue
5 INPUT : Green
6 INPUT : Light blue
7 INPUT : Purple
8 INPUT : Pink
(3) Other color data is set in the same way.
(Note) The following colors are used if the default colors are designated.
Material color
Machining surface color
Tap machining surface color : Light blue
Interference surface color
Cross section color
" 100.000 " appears at the cursor position.
The cursor moves one place down.
0 (mm)
-99999.999 to 99999.999
-99999.9999 to 99999.9999
-99999.99999 to 99999.99999
-99999.999999 to 99999.999999
The cell where the cursor is located appears in gray.
The cursor moves one place down. (The cursor does not
move when at the cross section color.)
: Gray
: Yellow
: Red
: Green
184
4.4 Program Check (3D)
#1041 I_inch
1 (inch)
-9999.9999 to 9999.9999
-9999.99999 to 9999.99999
-9999.999999 to 9999.999999
-9999.9999999 to 9999.9999999