Mitsubishi Electric FR-A800 Series Instruction Manual page 767

• The reply code (RWr10) to the instruction code execution is set in D2. (Refer to
SB49 SW0B0.0
0
M0 X20
3
M300
7
M301 X1025
9
M302 X1025
18
24
 Programming example for setting the operation commands
The following program gives a forward rotation command and middle-speed operation command to the station 1 inverter.
SB49 SW0B0.0
0
M0 X20
3
7
Y100F
b15
0 0 0 0
Run command
b0 : Forward rotation command
b1 : Reverse rotation command
b2 : High-speed operation command (RH)
b3 : Middle-speed operation command (RM)
b4 : Low-speed operation command (RL)
b5 : Jog operation selection (JOG)
*1 These signals are assigned in the initial status. Use Pr.180 to Pr.189 (Input terminal function selection) to change
the input signals. Some signals are not controllable by a command from the programmable controller depending on the
setting.
 Programming example for monitoring the output frequency
The following explains a program to read monitor functions of the inverter.
The following program reads the output frequency of the station 1 inverter to output to D1.
Output frequency read code: H0001 (hexadecimal)
For the monitor codes, refer to
766
5. PARAMETERS
5.21 CC-Link IE Field Network (FR-A800-GF)
Downloaded from ManualsNet.com
b7
0 0 0 0 0 0 0 0 1 0
[Run command]
Middle speed
b6 : Second function selection (RT)
b7 : Terminal 4 input selection (AU)
∗1 b8 : Selection of automatic restart after instantaneous power failure (CS)
b9 : Output stop (MRS)
∗1
∗1 b10 : Start self-holding selection (STOP)
∗1 b11 : Inverter reset (RES)
page 446.
search engine
Check the data link status of the station 1.
M0
PLS M300
SET M301
MOV H0FB W110
Write the operation mode write code (HFB)
to RWw10 and the set data (H0000) to RWw11.
MOV H0 W111
Turn ON the instruction code execution
SET Y1025
request (RY25).
RST M301
SET M302
Read the reply code (RWr10) to D2 when the instruction
MOV W10 D2
code execution completion (RX25) turns ON.
Turn OFF the instruction code execution
RST Y1025
request (RY25).
RST M302
END
M0
Check the data link status of the station 1.
Y1000
Forward rotation command (RY00)
Y1003 Middle-speed operation command (RY03)
END
Y1000
b0
0 1 RY3F to RY00
1: ON
Forward rotation
0: OFF
∗1
∗1
∗1
∗1
∗1
page 760 for the reply code (RWr10).)
One station
∗1