Basic Operation Procedure (Pu Operation); Setting The Frequency On The Operation Panel (Example: Operating At 30 Hz) - Mitsubishi Electric FR-A800 Series Instruction Manual

4.5
Select a method to give the frequency command from the list below, and refer to the specified page for its procedure.
Setting the frequency on the operation panel in the frequency setting mode
Give commands by turning the setting dial like a potentiometer
Give commands by turning ON/OFF switches wired to inverter's terminals (multi-speed setting)
Setting the frequency by inputting voltage signals
Setting the frequency by inputting current signals
4.5.1
• Use the operation panel (FR-DU08) to give a start command and a frequency command. (PU operation)
The following shows the procedure to operate at 30 Hz.
Operating procedure
1.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
2.
Changing the operation mode
Press
3.
Setting the frequency
Turn
While the indication is flashing, press
displayed alternately. After about three seconds of alternate display, the monitor display goes back to "
indication of a monitored value).
(If
Hz). In that case, turn
4.
Start → acceleration → constant speed
Press
Pr.7 Acceleration time, and "
(To change the set frequency, return to step 3. The previously set frequency appears.)
Downloaded from ManualsNet.com

Basic operation procedure (PU operation)

Method to give the frequency command
Setting the frequency on the operation panel
(example: operating at 30 Hz)
to choose the PU operation mode. [PU] indicator turns ON.
until the target frequency "
is not pressed during the flashing for about five seconds, the monitor display goes back to "
again and set the frequency.)
or to start running. The frequency value on the monitor increases according to the setting of
search engine
Operation panel (FR-DU08)
" (30.00 Hz) appears. The indication blinks for about five seconds.
to confirm the selection for the frequency. "
" (30.00 Hz) appears on the monitor.
Refer to page
149
150
151
152
153
" and "
4. BASIC OPERATION
4.5 Basic operation procedure (PU operation)
1
2
3
4
5
6
7
8
9
10
"are
" (the
" (0.00
149