Component Names Of The Cc-Link Ie Field Network Communication Circuit Board - Mitsubishi Electric FR-A800 Series Instruction Manual

 Connection cable
• For wiring, use the 1000BASE-T compliant Ethernet cables.
Category 5e or higher straight cable (double shielded/
STP)
• Recommended products (as of October 2020)
Model
SC-E5EW series
*1 SC-E5EW cable is for in-enclosure and indoor uses. SC-E5EW-L cable is for outdoor use.
NOTE
• For CC-Link IE Field Network wiring, use the recommended wiring components by CC-Link Partner Association.
• Cables for CC-Link IE Controller Network cannot be used for CC-Link IE Field Network.
• Depending on the cable connector shape, the cable may not be connected to the communication connector.
 Hubs
• Use hubs that meet the following conditions. Operation is not guaranteed if the hubs do not meet these conditions.
- Compliance with the IEEE802.3 (1000BASE-T)
- Support of the auto MDI/MDI-X function
- Support of the auto-negotiation function
- Switching hub (layer 2 switch)
*1 A repeater hub is not available.
• Industrial switching hub
Model
NZ2EHG-T8
2.11.4 Component names of the CC-Link IE Field Network
NOTE
• Do not remove the CC-Link IE Field Network communication circuit board or the earth plate.
Downloaded from ManualsNet.com
Ethernet cable
Manufacturer
*1
Mitsubishi Electric System & Service Co., Ltd.
*1
Manufacturer
Mitsubishi Electric Corporation
communication circuit board
search engine
Board mounted option connector
RJ-45 connector
CC-Link IE Field Network communication
circuit board
Operation status indication LED
RUN D LINK
SD ERR
RD L.ERR
Connector for communication (PORT2)
Connector for communication (PORT1)
Earth plate
2.11 Wiring for use of the CC-Link IE Field Network (FR-A800-GF)
Type
The following conditioning cables:
• IEEE802.3 (1000BASE-T)
• ANSI/TIA/EIA-568-B (Category 5e)
2. INSTALLATION AND WIRING
1
2
3
4
5
6
7
8
9
10
111