Mitsubishi Electric FR-A800 Series Instruction Manual page 746

 Copying parameter settings stored in the operation panel to the inverter
Operating procedure
1.
Connect the operation panel to the destination inverter.
2.
Selecting the parameter setting mode
Press
3.
Selecting the parameter
Turn
"
4.
Selecting parameter copy
Turn
5.
Copying to the inverter
Press
"
● Perform this step while the inverter is stopped. (Parameter settings cannot be copied during operation.)
6.
End of copying
"
7.
When parameters are written to the destination inverter, reset the inverter before operation by, for example, turning
the power supply OFF.
NOTE
• "
• "
or lower or FR-A840-01800(55K) or lower inverters and the FR-A820-03800(75K) or higher or FR-A840-02160(75K) or higher
inverters. When CP and 0.00 are displayed alternately, set Pr.989 Parameter copy alarm release as shown in the following
table (initial value).
• After setting Pr.989, perform setting of Pr.9, Pr.30, Pr.51, Pr.56, Pr.57, Pr.61, Pr.70, Pr.72, Pr.80, Pr.82, Pr.90 to Pr.94,
Pr.453, Pr.455, Pr.458 to Pr.462, Pr.557, Pr.859, Pr.860, and Pr.893 again.
Downloaded from ManualsNet.com
to choose the parameter setting mode. (The parameter number read previously appears.)
to " " (Parameter copy), and press
" appears.
to change the set value to "
appears.
to start copying to the inverter. (It takes about 60 seconds to copy all the settings. During copying,
" blinks.)
" and " " are displayed alternately after copying ends.
" appears when a parameter write error occurred. Perform the operation from step 3 again.
" and " " are displayed alternately when parameter copy is performed between the FR-A820-03160(55K)
Pr.989 setting
10 Cancels the warning of FR-A820-03160(55K) or lower and FR-A840-01800(55K) or lower.
100 Cancels the warning of FR-A820-03800(75K) or higher and FR-A840-02160(75K) or higher.
search engine
.
", then press .
Operation
5.18 Copying and verifying parameters on the operation panel
1
2
3
4
5
6
7
8
9
10
745
5. PARAMETERS