Table of Contents
Advertisement
M-101
M-101
General Description
This feature allows an office receiving ANI information by means of MF signal to output the information to the
expanded SMDR area.
Operating Procedure
No manual operation is required.
Service Conditions
1.
Output conditions are same as current conditions of MF ANI. (i.e., charging information for incoming
calls is output only).
2.
About the expanded output format, refer to SMDR OUTPUT EXPANSION-ANI/CPN [S-129].
3.
When the tandem connection is established through CCIS, the maximum digits of ANI information output
to the SMDR port are 16.
Programming
Also see TRUNK LINE APPEARANCE
term
a D
line/feature key.
STEP 1:
ASYD - System Data 1, Index 241, Bit 4. 0/1 = No ANI output to SMDR/ANI output to SMDR.
System Data 1, Index 241, Bit 6. 0/1 = When the length of Caller ID exceeds the limit, only the former/
latter part of data appears on the LCD.
System Data 1, Index 390, Bit 0. Caller ID display pattern on the LCD. 0/1 = Calling Number/Calling
Name has priority.
System Data 1, Index 390, Bit 2. when using D
displaying Caller ID. 0/1 = Out/In service.
When Calling Number is output to SMDR, the following expanded format is used.
S
O
!
T
X
Page 536
MF ANI to SMDR
MF ANI to SMDR
1
2
96
K
H
OFFICE CODE OF
/
CALLED PARTY
I
(FOR CCIS)
/
J
H = Origination
I = Termination
J = Station-to-Station
[T-23]
for information on how to accommodate C.O. line on
term
2-line LCD, the lower LCD can be used for
104
AUTH
CODE
A = ANI Information
Identifier:
0 = Output is not available
1 = Displayed
2 = Display denied
3 = Service is not available
4 = Origination from public pay phone
Note: For 0, 2 and 3, the ANI number is not output.
NEAX2400 IPX Feature Programming Manual
129 130
131
162
A
ANI
Z
E
NO.
T
X
Z = End of SMDR
Information
NDA-24297, Issue 1
Advertisement
Table of Contents
