Table of Contents
Advertisement
Programming (cont'd)
term
For a D
STEP 1:
AKYD - Assign the station according to the following parameters:
TN:
1
STN:
Station Number
TP:
Type of D
RING:
0: No Ringing
1: Ringing All Lines
2: Ringing on Prime Line Only
3: Flexible Ring Assignment, enables RG parameter.
KYN: Key Number (1-40)
KYI:
Service Index
0: Key Not Used
1: Feature Key
2: Multi-line Key
KD:
Not assigned for Feature Key
FKY: Feature Key Number
FKY
= 14, VOICE CALL.
STEP 2:
ADSL - Assign VOICE key; Assign SN=2 (Originating; RBT Connection) and FKY=14 (Voice Call).
This command is used for assigning a function to each soft key.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ANPDL - Reserve a number level for feature access. Assign Connection Indexes, CI = N, H, B;
Normal (N), Hooking (H), and Busy (B) (applicable to any feature assigned to this level). Assign NND
in accordance with a predetermined numbering plan.
STEP 2:
ASPAL - Assign an access code to VOICE CALL, SRV = SSCA, SIDA = 41.
Connection Status CI = H, Hooking (H).
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
term
0/1:
Note
Voice Call
V-2
Page 791
Advertisement
Table of Contents
