Table of Contents
Advertisement
P-5
Pushbutton Calling - Attendant Only
General Description
This feature permits an Attendant to place all calls over DTMF signaling lines from a pushbutton keypad on the
ATTENDANT CONSOLE [A-3].
Operating Procedure
Attendant presses the pushbutton keypad to dial.
Service Conditions
1.
This feature requires that all Central Office trunks and TIE Trunk terminals accept pushbutton signaling
(DTMF).
2.
PUSHBUTTON CALLING - ATTENDANT ONLY may be added to the system without providing
PUSHBUTTON CALLING [P-4] capability to other stations.
Interactions
The Attendant Console must first be provided.
Programming
STEP 1:
ASYD - System Data 1, Index 128. Register Prepause Timer. How long the register waits for the first
digit. Normally assign data 00H for 12 seconds.
System Data 1, Index 134. Register Inter-digit Timer for the Attendant Console. How long the register
waits between digits. Normally assign data 00H for four seconds.
System Data 2, Index 2, Bit 1. Sender signal for Attendant Console is DP/PB? 0/1: DP/PB. Assign as
appropriate.
STEP 2:
ATRK - Assign Originating Register Trunks (ORT) to the Attendant Console (optional). Registers are
located on levels 0-3 of any 8RST circuit card.
Also, senders must be assigned to the system in a quantity calculated from expected traffic.
RT:
Trunk Route Number
Intra-office Route Number (901-931)
901-ATT
902-ORT
903-IRT
905-Sender 916-MFCR
909-DCFT 917-MFCS
TK:
TN:
RSC:
SFC:
STEP 3:
ARTD - Routes must be assigned as either PB, DP, or DP/PB. CDN 2:ONSG, Type of Outgoing
Signal Selection, is assigned to each route as data "1", DP; data "2", PB; or data "3", DP/PB.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Pushbutton Calling - Attendant Only
Route Number
912-ORT for ATT
913-TCFT for ATT
915- Night ATT
919 to 926-Modem
Trunk Number
Tenant Number
Route Restriction Class
Service Feature Class
P-5
Page 581
Advertisement
Table of Contents
