Table of Contents
Advertisement
C-7
Interactions (cont'd)
9.
Stations denied access to a route via Route Restriction Class may not use CALL PICKUP GROUP to
answer restricted incoming trunk calls.
10.
CALL PICKUP GROUP is not available for AUTOMATIC/MANUAL INTERCOM [A-30] or DIAL
INTERCOM [D-87] calls.
11.
If more than one station line in a CALL PICKUP GROUP is ringing, the individual call answered is
selected by the system. The system priority is based on a circular chain arrangement with first priority
given to the station following the station dialing the pick up code.
12.
A call ring in a recall state cannot be picked up with this feature.
Programming
STEP 1:
ANPD - Reserve a number level for feature access and cancel. Assign for Normal (N). Assign NND in
accordance with a predetermined numbering plan.
STEP 2:
ASPA - Assign an access code for the CALL PICKUP GROUP, SID = 7 and the CALL PICKUP
EXPAND, SIDA=63 (if necessary) for Connection Status Index (CI) of Normal (N) and Hooking (H).
STEP 3:
ACPG - Assign members of CALL PICKUP GROUP. If two stations are ringing simultaneously, the
station that was programmed first will be picked up first.
STEP 4:
ACPE - Assign the CALL PICKUP EXPAND GROUP (if necessary).
STEP 5:
AKYD - Optional. Assign a programmable Line/Feature key as a CALL PICKUP key. Assign
Type:Function:CALL PICKUP-GROUP [12]. If necessary, assign Type:Function:CALL PICKUP
EXPAND [115].
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ANPDN - This command must be assigned to the NCN.
Reserve a number level for feature access and cancel. Assign for Normal (N).
Assign NND in accordance with a predetermined plan.
STEP 2:
ASPAN - This command must be assigned to the NCN. Assign access code for CALL PICKUP,
CI=N, SRV=SSC, SID=7 (CALL PICKUP - GROUP). If necessary, assign SRV=SSCA, SIDA=63
(CALL PICKUP EXPAND GROUP).
CI=N (Normal)
SRV=SSC
SID=7 (CALL PICKUP GROUP)
STEP 3:
ACPGN - This command must be assigned to the NCN.
Assign members of CALL PICKUP GROUP.
UGN: User Group Number
TELN: Telephone number in CALL PICKUP GROUP
STEP 4:
ACPEN - This command must be assigned to the NCN.
Assign the CALL PICKUP EXPAND GROUP (if necessary).
UGN: User Group Number
TELN: Telephone number in CALL PICKUP EXPAND GROUP
Page 148
Call Pickup - Group
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
