Table of Contents
Advertisement
A-82
Programming (cont'd)
0/1:
Redial is prompted by sending the second announcement/forcible disconnect
Bit 6: Processing on PB Receiver Time-out.
0/1:
Forcible disconnection/Transfer to ATT
Index 128: Assign the timer value of Register Prepause Time.
Index 139: Assign the value of No Answer Timer (Call Forwarding - All Calls, Call Back, etc.)
Index 246, Bit 4:
Process of incoming calls (Ringdown) after they encounter their 1st, 2nd PB receiver time-out in a
sequence of Automated Attendant.
0/1:
Forced Release/Transfer to ATT
STEP 2:
ARTD - Assign the route data of the trunk for AUTOMATED ATTENDANT.
RT:1
1-OSGS
Assign the route data of the Digital Announcement Trunk.
STEP 3:
ATRK - Assign the trunk data of both the trunk for AUTOMATED ATTENDANT and the Digital
Announcement Trunk. Also, assign the trunk data of PB Receiver (RT = 906).
STEP 4:
MBTK - Cancel the Make-Busy of the trunk assigned by ATRK.
STEP 5:
ACSI - Assign CSI = 5 (Remote Access to PBX) to the route and trunk number of the trunk for
AUTOMATED ATTENDANT.
STEP 6:
ACFR - Assign the restriction release of TSFI = 7 (Remote Access to PBX)
STEP 7:
AAED - Assign the Announcement Equipment for AUTOMATED ATTENDANT.
Announcement Equipment for sending the first announcement.
(EQP = 34, C = 0, R = 1, A = 1, M = 0)
Announcement Equipment for sending the second announcement
(EQP = 35, C = 0, R = 1, A = 1, M = _)
Note 1:
When ASYD, SYS1, Index 7, b=5 =0, assign the Announcement Equipment to send the second
announcement.
Note 2:
When selecting M (0 = Single / 1 = Multi) for the second announcement, take the following into account:
Do not assign the second announcement in the same route as the first announcement when Multi (M = 1) is
selected. In the case of Multi (M = 1), the DAT trunk is forcibly released when 30 seconds have elapsed
from the beginning of the second announcement. Note that the connection of the DAT trunk still remains
even if the playback reaches the end of the recorded announcement. In the case of Single (M = 0), the DAT
trunk is automatically released when the playback reaches the end of the recorded announcement.
STEP 8:
ASTD - Assign the following state translation data:
STM = 0, STS = 2, ST = 1 (allows a tandem connection inclusive of COT)
STM = 4, STS = 0, ST = 1 (remote access to PBX in service)
STEP 9:
ARRC - Cancel the restrictions on the trunk route for AUTOMATED ATTENDANT and the route for
the Digital Announcement Trunk.
ICRT: (Trunk route for AUTOMATED ATTENDANT)
OGRT: (Route for Digital Announcement Trunk)
ARI-D-RES
STEP 10: ARAC - Assign an idle station number as the Remote Access Code.
Page 60
Automated Attendant
:2
4-INSG
:2 or 7
6-TCL :4
Note 2
Note 1
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
