Table of Contents
Advertisement
Operating Procedure (cont'd)
To cancel Call Forwarding from the Attendant Console
1.
Cancelling Call Forwarding for an incoming call from a station:
a.) Press an idle loop key and dial the cancel code for FORWARD, FORWARD-BY, or
FORWARD-DA for an incoming call from a station; receive special dial tone.
b.) Dial the Tenant Number (2 digits) of the originating station and the originating telephone number.
c.) Press the RELEASE key; receive service set tone.
2.
Cancelling Call Forwarding for an incoming call from an outside party:
a.) Press an idle loop key and dial the FORWARD, FORWARD-BY, or FORWARD-DA access
code for an incoming call from an outside party; receive special dial tone.
b.) Dial the Tenant Number (2 digits) of the originating station and the originating telephone number;
receive service set tone.
c.) Press the RELEASE key.
Service Conditions
1.
The same station can be set as the transfer target station for an incoming call from an outside party and/or
from a station.
2.
For an incoming call from a trunk, whether Call Forwarding destination for an incoming call from a station
or for an incoming call from an outside party is to be used can be designated on each incoming route basis.
(According to ARTD command, CDN 68:SCF, data.)
3.
When an incoming call from a trunk is handled via the Attendant/station, the destination of Call
Forwarding is selected according to the route data of the incoming trunk (as assigned by ARTD command,
CDN 68:SCF).
4.
This service is invalid on Call Forwarding by the system. (Call Forwarding by the ACFO command.)
5.
Multiple Call Forwarding is available for those stations where SPLIT CALL FORWARDING has been
set.
6.
This service can be set from the Attendant Console.
Station A
Station B
Station C
Ex. In a case where station A has set Station B as the transfer target station for an incoming call from a station, and has
set Station C as the transfer target station from an incoming call from an outside party.
•
When a call from a station terminates to Station A, the call is transferred to Station B.
•
When a call from TRK A terminates to Station A, the call is transferred to Station C.
•
When a call from TRK B terminates to Station A, the call is transferred to Station B.
7.
Indication of SPLIT CALL FORWARDING (ALL CALLS/BUSY LINE/DON'T ANSWER) feature can
be accomplished only if the Service Feature Restriction Class and access codes are assigned properly.
8.
This feature is available for stations where CALL FORWARDING services are available by CLASS OF
SERVICE.
9.
Multiple Call Forwarding is available for those stations where SPLIT CALL FORWARDING has been
set.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Split Call Forwarding
Trunk route assigned to ARTD, SCF = 1
TRK A
Trunk route assigned to ARTD, SCF = 0
TRK B
S-99
Page 719
Advertisement
Table of Contents
