NEC NEAX2400 IPX Programming Manual page 244

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

General Description

This service feature allows a D

putting an existing call on HOLD [C-6], by pressing the ANSWER key.

Operating Procedure

CAMP-ON [A-1] or CALL WAITING [C-12, 31] to a busy D

The user hears Camp-On Indication Tone or Call Waiting Tone during a call in progress; the LCD of the

The user presses ANSWER key and is connected to the waiting call.

To return to the original call, the D

Service Conditions

Service conditions are essentially the same as those of CALL WAITING - TERMINATING [C-12] for

ordinary telephone sets.

Pressing RECALL will disconnect the party presently engaged in conversation.

Interactions

This feature is allowed whenever the destination telephone is engaged in any state other than:

a.) engaged in a 3-way connection,

b.) a Privacy feature is activated,

c.) connected to a route programmed to have Line/Trunk, Privacy, CDN 44:PRV,

d.) listening to a tone (dial tone, reorder tone, service set tone, busy tone, ringback tone).

CALL WAITING-ANSWER-D

instrument. This feature is used for ATTENDANT CAMP-ON [A-1] and CALL WAITING-

ORIGINATING [C-31].

Periodic Call Waiting Tones will not operate for ATTENDANT CAMP-ON WITH TONE INDICATION

ASYD - System Data 1, Index 152. Timer class 3 = 2 seconds. MTC x TC = Interval for CALL

WAITING. MTC assigned in hexadecimal to bits 0 ~ 3 of this index. Default value is 10 seconds.

System Data 2, Index 10, bit 6. Should CALL WAITING - ORIGINATING [C-31] operation be

automatic upon encountering a busy station? 0/1: No/Yes. Assign on a per tenant basis.

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1

Call Waiting - Answer - D

user to answer a CAMPED-ON [A-1] or CALL WAITING [C-12, 31] call while

(Time Display)

(Time Display)

user re-presses ANSWER key.

is operated by pressing the ANSWER key located on the D

is activated

Trunk/Telephone Number

Trunk/Telephone Number