Table of Contents
Advertisement
Service Conditions (cont'd)
7.
Other interactions are the same as for DTMF signal dialing.
8.
FCCS link is not available for this feature.
Programming
STEP 1:
ARTD - Assign route class data to the route number of the outgoing trunk.
RT:1
1-OSGS
19-EANI
STEP 2:
AAND - Assign ANI sending digit as per the route number and the number of digits of the caller's
number.
When AT = 0:
RT:
Route Number
AT:
0/1 = STA outgoing / ATT outgoing
CC
= 0
KT:
Expansion of Station Number Length*
0/1=OFF/ON
STNL: Station Number Length (When KT = 1)
SKIP: Call Originator Digit to be Skipped
ADD: ANI Information Additional Number of Digits
DC:
ANI Sending Number
Note:
When 0 has been assigned to parameter KT and when the Station Numbers used consist of a different
number of digits, outgoing routes must be divided on the basis of each number of digits.
When 1 has been assigned to parameter KT, outgoing routes need not be divided, even if the Station
Numbers used consist of a different number of digits.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Automatic Number Identification (ANI)
:7
2-ONSG
:4
:1
3-ISGS
:7
4-INSG
A-78
:4
15-LSG
:5
Page 57
Advertisement
Table of Contents
