Table of Contents
Advertisement
Service Conditions (cont'd)
12.
Stations are assigned this feature according to TENANT SERVICE [T-12] of the calling and destination
stations, when the called station does not answer for a predetermined time interval. In the following cases,
when the calling or destination stations are restricted by TENANT SERVICE [T-12] class, this feature is
not activated, and the called station continues to ring:
a.) when a station places a call to another station setting CALL FORWARDING - DON'T
ANSWER,
b.) when a station holding an original call (station or trunk) on CONSULTATION HOLD [C-17]
places a call to a station setting CALL FORWARDING - DON'T ANSWER.
13.
Call Transfer - Attendant (Trunk): Trunk calls transferred by the Attendant are assigned this feature
according to Route Restriction Class of the trunk and the destination station when the station does not
answer for a predetermined time interval. When restricted by Route Restriction Class, this feature is not
activated, and the called station continues to ring.
14.
Call Transfer - Attendant (Station): Station calls transferred by the Attendant are assigned this feature
according to TENANT SERVICE [T-12] class of the originating and destination stations when the called
station does not answer for a predetermined time interval. When restricted by TENANT SERVICE class,
this feature is not activated, and the called station continues to ring.
15.
Speed Calling List numbers may be programmed as the destination telephone number. This permits the
sent digits to exceed the 12-digit maximum.
16.
CALL FORWARDING - DON'T ANSWER data remains in the data memory, even if the system or LP is
reinitialized.
17.
When a call is transferred from the Attendant to a station that has set CALL FORWARDING - DON'T
ANSWER, this feature may be restricted or activated according to System Data (SYS2, Index 6, Bit 7).
18.
A call can be forwarded to an Attendant Console in the remote node via FCCS link.
Attendant
Console B
19.
When a call is forwarded through FCCS link, the numbering plan of the originally called station must be
identical with that of the forwarded Attendant Console.
Interactions
1.
If access code for CALL FORWARDING-BUSY LINE [C-2] and CALL FORWARDING-DON'T
term
ANSWER-D
2.
ACFO is applicable to DID, DIT, and TIE Line calls only.
3.
A non-controlling UCD station is allowed to activate CALL FORWARDING-DON'T ANSWER-D
When this station sets Call Forwarding, calls directed to this station will be call forwarded. The member
station is not removed from the UCD group under the conditions of which the Call Forwarding feature is
used. When it is the station's turn to ring, that call is affected by CALL FORWARDING-DON'T
ANSWER - D
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - Don't Answer - D
A
Node
FCCS Link
are the same, only one key needs to be assigned in AKYD.
term
.
term
B
Node
TK
Station A has been set
Call Forwarding service to
Attendant Console B
C-3D
term
.
Page 127
Advertisement
Table of Contents
