Table of Contents
Advertisement
D-7
Service Conditions (cont'd)
17.
When activating this feature via the FCCS network, when the telephone number of the destination station
is deleted:
a.) When the Attendant Console is used, the DIT call terminates to the Attendant Console.
b.) When the Attendant Console is not used, or if the Attendant Console is in night mode, the caller
hears ringback tone.
18.
When activating this feature via the FCCS network, a DIT call cannot be queued while all the FCCS links
are busy. Calling party receives ringback tone at that time and after the FCCS link is restored to idle.
19.
When activating this feature via the FCCS network, the different destination for C.O. incoming call (ring
down) cannot be set at each tenant group.
Interactions
1.
Night DIT service is NIGHT CONNECTION - FIXED [N-1]. The NIGHT CONNECTION - FIXED/
FLEXIBLE [N-1, 2] feature can be used to simulate a DIT application.
2.
When using NIGHT CONNECTION - FIXED/FLEXIBLE [N-1, 2], if the station is busy, the call will
divert to TRUNK ANSWER ANY STATION [T-8], if provided. If not provided, the call will queue at the
busy station until it becomes idle.
3.
The DIRECT-IN TERMINATION trunk is limited to the following types:
a.) DDD
b.) FX
c.) WATS
d.) CCSA
4.
All CALL FORWARDING [C-2, 3, 5] features may be used in conjunction with DIRECT-IN
TERMINATION. In the case of CALL FORWARDING - DON'T ANSWER [C-3], the call must
physically be ringing the DIT station. Call Forwarding is only available from a ground start DIT trunk.
5.
STATION HUNTING [S-7, 8, 9] and UNIFORM CALL DISTRIBUTION (UCD) [U-1] may be used
with DIRECT-IN TERMINATION.
Programming
STEP 1:
ASYD - System Data 2, Index 11, Bit 7. Will the DIT call to a busy station be routed to the Attendant
Console, or will it queue to the busy station? 0/1: Attendant Console/Queue. Assign on a per-tenant
basis. If the call goes to the Attendant Console, it will ring in on the BUSY or ICPT key.
System Data 1, Index 147. DIT supervisory timer for a busy station. How often will the CPU look at
the Idle/Busy status of the station for rerouting the DIT call to the destination? This index works when
System Data 2, Index 11, Bit 7 is 1.
STEP 2:
ARTD - Assign the DIRECT-IN TERMINATION route as shown below:
GROUND START:
RT: 1
1-OSGS
6-TCL
LOOP START:
RT:1
1-OSGS
6-TCL
STEP 3:
ATRK - Assign the LENs, DIT Trunk Route Number, Trunk Number, and Tenant Number.
STEP 4:
MBTK - Assign the Make Idle status to the DIT trunk.
Page 278
Direct-In Termination (DIT)
:2
2-ONSG
:3
:1
7-L/T
:1
:2
2-ONSG
:3
:1
7-L/T
:1
3-ISGS
:1
4-INSG
8-RLP
:2
15-LSG
3-ISGS
:1
4-INSG
8-RLP
:2
NEAX2400 IPX Feature Programming Manual
:3
5-TF
:2
:1
:3
5-TF
:2
NDA-24297, Issue 1
Advertisement
Table of Contents
