Table of Contents
Advertisement
R-49
R-49
General Description
This feature allows a user to stop ringing by pressing the associated feature key on the D
Operating Procedure
term
1.
The D
user presses the RINGER MUTE key; the ringing is muted and the LED of the key lights. RING
OFF is displayed for three seconds.
term
2.
The D
user presses the RINGER MUTE key again; the ringing is recovered and the LED of the key is
turned off. RING ON is displayed for three seconds.
Service Conditions
1.
The feature key for Ringer Mute must be assigned to the D
2.
Ringer Mute which has been set becomes ineffective upon system initialization, individual initialization
of LP or initialization of PM.
3.
While this service is activated, ringing for Call Back is not provided as well.
4.
This service has no effect on the status of DO NOT DISTURB [D-11] service. For example:
a.) When Do Not Disturb is set, the station is in the Do Not Disturb status.
b.) When Ringer Mute is set, the station is in the Do Not Disturb and Ringer Mute status.
c.) When Do Not Disturb is reset, the station is in the Ringer Mute status.
5.
When this service is activated, ringing for any call is muted.
6.
If a user presses the RINGER MUTE key while a call is terminating, ringer for this call will be muted.
Programming
STEP 1:
AKYD - For D
Type:Function:RING MUTE [117].
STEP 2:
ADSL - Assign SN = 0 (Idle) and FKY = 117 (Ringer Mute: RG-OF).
This command is used for assigning the function to each soft key.
Page 634
Ringer Mute
Ringer Mute
term
sets, RINGER MUTE may be assigned to a programmable line/feature key. Assign
term
.
term
.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
