Table of Contents
Advertisement
Service Conditions (cont'd)
11.
FPC of a node which transmits Day/Night changeover information is determined by System Data 1 Index
640, and the information is transmitted to a node of FPC designated by System Data 1 Index 704.
The maximum number of telephone numbers that can be programmed in the system is 65,535.
Note 1:
12.
A station within the FCCS network can be assigned as forwarding destination for Night Mode (LDN
NIGHT CONNECTION [L-28]).
13.
The order of priority of forwarding features used when the system is Night Mode are as follows.
1. NIGHT CONNECTION FLEXIBLE
2. NIGHT CONNECTION FIXED
3. LDN NIGHT CONNECTION
4. NIGHT CONNECTION-OUTSIDE-SYSTEM
5. TRUNK ANSWER FROM ANY STATION (TAS) [T-8]
The value of 1 is the highest priority, the value of 5 is the lowest priority.
Note 2:
When forwarding destination for this feature is not assigned, busy tone is sent.
Note 3:
14.
When assigning a forwarding destination number for Night Mode using ALDNN command, the maximum
16 digits can be programmed by using TYPE = 1 (Station Number) / 2 (DC). If the user requires digit
number greater than 16 or more, assign an Abbreviated Digit Number (ADC) of the forwarding
destination, preprogrammed by ASPD command, by using TYPE = 3 (Abbreviated Digit Number).
15.
The user can assign different forwarding destination numbers (Telephone Number) to each LDN.
The maximum number of telephone numbers that can be programmed in the system is 65,535.
Note 4:
16.
Whether special transmission tone is sent or not while number data is transmitted depends on System Data
1 Index 6 Bit 0.
17.
Forwarding destination terminal, available for this feature, is station or Voice Prompt System (VPS).
18.
When using VPS as forwarding destination of this feature, the user programs voice information guidance
number, recording service number or etc. As regards numbering plan for these service, refer to service
condition of VPS.
19.
Forwarding features (except for following) are available for forwarding destination:
CALL FORWARDING-ALL CALLS
CALL FORWARDING-BUSY LINE
CALL FORWARDING-DON'T ANSWER
CALL FORWARDING-ALL CALLS-OUTSIDE
CALL FORWARDING-BUSY LINE-OUTSIDE
CALL FORWARDING-DON'T ANSWER-OUTSIDE
CALL TRANSFER-ATTENDANT
20.
A route between incoming trunk received a LDN call and forwarding station for the LDN call is not
restricted.
21.
When STATION HUNTING-CIRCULAR [S7], STATION HUNTING-TERMINAL [S-9] or UNIFORM
CALL DISTRIBUTION (UCD) [U-1] is set to the forwarding destination, the hunting feature is available.
22.
NIGHT CONNECTION FIXED [N-1] or TRUNK ANSWER FROM ANY STATION [T-8] is available
while the destination is in the following states:
•
Forwarding destination is not assigned by ALDNN command.
•
CALL FORWARDING-BUSY LINE [C-2] to ATTCON is set.
•
CALL FORWARDING-ALL CALLS [C-5] to ATTCON is set.
•
CALL FORWARDING-INTERCEPT/ANNOUNCEMENT [C-25] is set.
•
CALL FORWARDING-BUSY LINE-OUTSIDE [C-28] is set.
•
CALL FORWARDING-ALL CALLS-OUTSIDE [C-60] is set.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
LDN Night Connection
[N-2]
[N-1]
[L-28]
[N-17]
[C-28] to ATTCON
[C-2] to ATTCON
[C-3] to ATTCON
[C-28]
[C-60]
[C-74]
[C-10]
L-28
Page 453
Advertisement
Table of Contents
