Table of Contents
Advertisement
P-11
P-11
General Description
This feature provides a tone every 180 seconds, if required, to the user who has made an outgoing call.
Operating Procedure
No manual operation is required.
Service Conditions
1.
This feature is programmed on a per-trunk route basis using the MAINTENANCE ADMINISTRATION
TERMINAL (MAT) [M-18].
2.
The PERIODIC TIME INDICATION TONE is 80 ms in duration and is sent every 180 seconds. See
VARIABLE TIMING PARAMETERS
3.
This feature is only available for users who have placed outgoing calls to a Central Office line or to a TIE
Line.
4.
Incoming calls or outgoing calls initiated by the Attendant will not have this feature.
5.
When the user activates SPECIAL DIAL TONE after the outgoing call mode, this feature will be cancelled
automatically.
6.
When the user activates the following service features after the outgoing calls to a Central Office line or
to a TIE Line, this feature will be cancelled automatically:
ATTENDANT CAMP-ON WITH TONE INDICATION
ATTENDANT OVERRIDE
BOSS-SECRETARY OVERRIDE - D
BUSY VERIFICATION
CALL HOLD
CALL TRANSFER
CALL WAITING - ORIGINATING
CALL WAITING - TERMINATING
CONSULTATION HOLD - ALL CALLS
DATA PRIVACY ON DEMAND
EXCLUSIVE HOLD - D
EXECUTIVE RIGHT-OF-WAY
NON-EXCLUSIVE HOLD - D
OFF-HOOK QUEUING
OUTGOING TRUNK QUEUING
PRIVACY RELEASE
THREE-WAY CALLING
VOICE CALL - D
Interactions
1.
The timers set in System Data 1, Indexes 137 and 138 are approximate. Expect errors of ± 40 seconds.
Keeping track of time for this service is a very low priority for the CPU.
2.
PERIODIC TIME INDICATION TONE is used for outgoing connections only.
Page 594
Periodic Time Indication Tone
Periodic Time Indication Tone
[V-1]
term
term
term
for other programming time periods.
term
NEAX2400 IPX Feature Programming Manual
[A-1]
[A-7]
[B-5D]
[B-3]
[C-6, C-6D]
[C-10, C-11, C-11D]
[C-31]
[C-12]
[C-17, C-17D]
[D-17]
[E-4D]
[E-1, E-1D]
[N-7D]
[O-7]
[O-2, O-2D]
[P-18]
[T-2, T-2D]
[V-2D]
NDA-24297, Issue 1
Advertisement
Table of Contents
