Table of Contents
Advertisement
Programming
STEP 1:
Referring to the NEAX2400 IPX No. 7 CCIS System Manual, assign the entire basic data (such as
ASYD, ARTD, ATRK, ADPC, ACSC, ACIC1, ACIC2, MBTK, etc.) necessary for the establishment
of a CCIS Tie Line.
Enter IPTRK = 1 for both D-channel and B-channel routes on the ARTI command.
For the port assignment (B-ch) of the IPTRK card, see the IPTRK Circuit Card System Manual.
The CCIS signal controlling channel is determined in accordance with the CIC numbers of speech
channel. To provide multiple interfaces which vary from a single point code (taking CCIS and CCIS
network via IP services together within one network), CIC numbers and CICG (CIC Group) must be
assigned on the same interface. For further information, see the IPTRK Circuit Card System Manual.
STEP 2:
AGIP - Assign the IP addresses of IPTRK card and connected router.
Kind:
IPTEN:
IPTK_IP:
DG_IP:
ARP:
CLINK_NUM: Default value
SLINK_NUM: Default value
NETMSK:
MULT:
DST_IP:
QoS1:
QoS2:
NETID:
For further information, see the NEAX2400 IPX IPTRK Circuit Card System Manual.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
CCIS Networking via IP
IPTRK (CCIS)
Assign the 1st LEN of IPTRK accommodated HW block
Assign IP address of the IPTRK card
Assign IP address of the router
Select DIX
Assign IP address of the Net Mask
Select Point-to-Point
Assign IP address of the Destination Node IPTRK card
0-7
0-7
0-15
C-163
Page 879
Advertisement
Table of Contents
