Table of Contents
Advertisement
S-21
Programming (cont'd)
STEP 5:
AISA - Program the tenant, station, type of station, and the number of SPEED CALLING blocks to be
assigned to the Primary station.
TN:
STN:
MST/SLV: Primary/Secondary
BLOCK:
STN:
STEP 6:
AKYD - Type:Function:SPEED CALLING-STATION (GROUP) [26]
STEP 7:
ADSL - Assign G_SPD key; Assign SN=1 (Originating; DT Connection) and FKY=26 (Speed Calling
Station).
This command is used for assigning a function to each soft key.
STEP 8:
AISD - This command is used to assign, delete, and display the destination number of Individual
Speed Calling.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ANPDL - Reserve a number level for feature access. Assign Connection Indexes, CI = N, H, B;
Normal (N), Hooking (H), and Busy (B) (applicable to any feature assigned to this level). Assign NND
in accordance with a predetermined numbering plan.
STEP 2:
ASPAL - Two access codes must be assigned for this feature.
For the individual station speed calling number assignment, assign the tenant and Access Code (ACC).
Assign for a Connection Index of Normal (N). For SRV = SSC (Service Code), assign SID 14.
For individual station speed calling access, assign the tenant and Access Code (ACC). Assign for a
Connection Index of Normal (N). For SRV = SSC (Service Code), assign SID 21.
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
Page 696
Speed Calling - Station
Tenant Number
Station Number
M:
Primary Station
S:
Secondary Station
Number of Blocks
When assigning Secondary Station, assign the Primary Station number.
Note
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
