NEC NEAX2400 IPX Programming Manual page 564

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

General Description

This feature permits D

key (SIG key) is operational at all times. An Intercom call is not required. If the signalled station is ringing from

another call, the manual intercom signal will interrupt that ringing.

Operating Procedure

Press the SIG key; send a one-second ring to the predetermined station.

Service Conditions

When MANUAL SIGNALING is initiated by a user, this one-second ring takes priority over any other

incoming call indications from the multi-line appearances.

can be assigned a manual SIG key.

One destination station can be assigned for manual signaling through the MAINTENANCE

ADMINISTRATION TERMINAL (MAT) [M-18].

Stations that can signal each other must be assigned in the same Module Group.

A station can manually signal one other D

MANUAL SIGNALING is an operation of MANUAL INTERCOM [A-30] and is used independently of

the MANUAL INTERCOM [A-30] feature.

This is also applied to FCCS service.

ASYD - SYS1, Index 59, Bit 7. Is AUTOMATIC/MANUAL INTERCOM [A-30] in service? 0/1: No/

AICD - For a station to manually signal another station, an AUTOMATIC/MANUAL INTERCOM

[A-30] group must be assigned. Bridge Call is not required. The maximum number of stations per

group may be assigned. Assign the intercom station number as the signaling station and the signaling

station number as the signaled station.

ICM STN: Intercom Station Number

AKYD - Assign to the station an Intercom Line according to the following parameters:

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1

Manual Signaling

users to send a one-second ring to a predetermined station. The manual intercom SIGNAL

Module Group

Group ID Number per MG

Automatic/Manual Signaling (0/1)

0: Automatic

Bridge Call Restriction (0/1)

0: Restricted

Tenant Number

Signaling Station Number

Station Number