Table of Contents
Advertisement
Service Conditions (cont'd)
13.
CALL FORWARDING-BUSY LINE - CCIS can be set by any number of stations to the same forwarded-
to station.
14.
The display of the forwarded-to telephone number on the LCD panel of the forwarding D
allowed or denied in system programming on a system-wide basis.
15.
When calls are forwarded to the Attendant Console, INCOMING CALL IDENTIFICATION [I-2] allows
the Attendant to identify the call as a forwarded call.
16.
When a call is call forwarded to the Attendant Console, the Attendant can identify the called station at the
Attendant Console.
17.
When a station sets CALL FORWARDING-BUSY LINE - CCIS to the Attendant Console, and the
system is in the Night mode, the calling party will receive reorder tone, or transfer to the ATTENDANT
NIGHT TRANSFER [A-19] station, if provided.
18.
When ATTENDANT CAMP-ON WITH TONE INDICATION [A-45] is directed to a station which has
set CALL FORWARDING-BUSY LINE - CCIS, and the forwarded-to station is busy, the call is camped-
on to the called station.
19.
If ATTENDANT CAMP-ON WITH TONE INDICATION [A-45] is directed to a station which is
forwarded to a busy station in a Hunt group, the call hunts for an idle station. If all stations in the Hunt
group are busy, the call is camped-on to the forwarded-to station.
20.
If a calling station, Attendant Console, or trunk receives busy tone after dialing a station which has set
CALL FORWARDING-BUSY LINE - CCIS because both the called and forwarded-to stations are busy,
and if the calling station activates BUSY VERIFICATION - CCIS [B-9], CALL BACK - CCIS [C-44],
CALL WAITING-TERMINATING [C-12], or EXECUTIVE RIGHT-OF-WAY - CCIS [E-8], these
services will be activated to the forwarded-to station.
21.
If any of the following restrictions are in effect at a forwarded-to station, incoming trunk calls to the
forwarding station will not be call forwarded (intercept arrangements will apply):
a.) Fully Restricted Station
b.) Station Restricted from Outgoing Calls
c.) Toll Restricted Station
22.
CALL FORWARDING-BUSY LINE - CCIS supersedes the station Hunting features [S-7, S-8, S-9].
23.
If a forwarded-to station is a member of a UCD group and that station is busy, the call will ring at an idle
station within the group. If all members of the group are busy, the call remains in queue waiting for a
member to become available; or (if programmed), until DELAY ANNOUNCEMENT-UCD [D-31] or
OVERFLOW-UCD [O-13] is invoked.
24.
If a member of a UCD group, other than the Pilot station, sets CALL FORWARDING-BUSY LINE -
CCIS, only calls to that extension number are forwarded.
25.
When a call is forwarded, the number recorded in the STATION MESSAGE DETAIL RECORDING [S-
10] is the forwarded-to telephone number.
26.
CALL FORWARDING-BUSY LINE - CCIS data remains programmed even if the system is reinitialized
without data memory clear or should a power failure occur.
27.
CALL FORWARDING-BUSY LINE - CCIS can also be accessed from a D
CALLING-ONE TOUCH [S-26D]. If this feature is accessed via the dial pad, it must also be cancelled
via the dial pad.
28.
If separate access codes are programmed into system data for CALL FORWARDING-BUSY LINE -
CCIS and CALL FORWARDING-DON'T ANSWER - CCIS [C-47], separate feature keys must be
programmed on each D
29.
If the station is in a Hunt Group, the call will hunt.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - Busy Line - CCIS
term
to equip it for both features.
term
can be
term
via the dial pad or SPEED
Page 837
C-46
Advertisement
Table of Contents
