NEC NEAX2400 IPX Programming Manual page 345

D-87
Operating Procedure (cont'd)
PRIME LINE PICK UP-D
term
The D may be programmed to seize the incoming call on the AUTOMATIC, MANUAL, or DIAL INTERCOM
lines before the Prime Line. If two incoming calls terminate simultaneously to both the Prime Line and the DIAL
INTERCOM line, when the user goes off-hook, PRIME LINE PICKUP-D
INTERCOM line before the Prime Line. If only the Prime Line is ringing when the user goes off-hook, then PRIME
term
LINE PICKUP D [P-13D] will seize the Prime Line. The programmable options and ringing priority are
illustrated in the following table:
RINGING
PRIORITY PRI0
1 Prime Line
2
3
Service Conditions
term
1. Only D s can be assigned as a member of a DIAL INTERCOM group.
2. All members of the same DIAL INTERCOM group must be assigned in the same Module Group.
3. Up to 32 stations may be assigned to one DIAL INTERCOM group. Each station in the DIAL
INTERCOM group can be assigned as an Automatic, a Manual and a DIAL INTERCOM member of three
different groups.
4. No more than one connection can be established at the same time in one DIAL INTERCOM group.
5. A three-party conference can be established in a DIAL INTERCOM group if Intercom Bridge service is
available. If a fourth party tries to activate Intercom Bridge service, the connection is denied.
6. The maximum number of DIAL INTERCOM groups in the PBX is 50 per Module Group.
7. It is possible to simultaneously assign one group of stations as an Automatic/Manual Intercom group, as
well as a DIAL INTERCOM group.
8. The distinctive ringing (three-burst ringing) sent from an incoming DIAL INTERCOM station takes
priority over the ringing of multi-line appearances.
9. Features normally available to multi-line appearances are not available to DIAL INTERCOM lines.
10. DIAL INTERCOM lines cannot be held by pressing the HOLD key.
11. When a station is moved from one DIAL INTERCOM group to another via system commands, the DICM
key on the associated D
12. Port traffic and station PEG COUNTS [P-7] reports will record the use of the DIAL INTERCOM feature
under "other."
term
13. Dedicated D
for hands-free operation can be used.
14. If there are simultaneous incoming calls to the Prime Line, Automatic Intercom Line, the Manual Intercom
Line, and/or the DIAL INTERCOM line, the Prime Line will normally be selected when the station goes
off-hook. The selection order can be changed for each D
15. DIAL INTERCOM group numbers are either one or two digits and can be set for each DIAL INTERCOM
group:
1 digit: 0-9
2 digits: 00-63
Page 302
term
[P-13D]
PRI1
Dial Intercom
-- Prime Line
-- --
term
must be deleted before the change is made.
feature keys cannot be used during a DIAL INTERCOM call. Only the SPEAKER key
Dial Intercom
PROGRAMMABLE OPTIONS
PRI2
Automatic Intercom Manual Intercom Automatic Intercom
Prime Line
--
term
via office data assignment.
term
[P-13D] will seize the DIAL
PRI3
Prime Line Manual Intercom
-- Prime Line
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
PRI4