Table of Contents
Advertisement
B-6
Programming (cont'd)
STEP 3:
AKYD - Assign to a D
TN:
STN:
TP:
KYN:
KYI:
KD:
TN, STN: Tenant Number and Station Number of Multi-line (Virtual)
RG:
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
AHLSN - This data must be assigned to the NCN.
UGN: User Group Number
TELN: Telephone Number of the calling party
TYPE: 1 (the called party is a station)
CON UGN:User Group Number of the called party
CON TELN:Telephone Number of the called party
The current data should also be set in addition to the command above.
Note:
The command to be set to the node accommodating the calling party: ASDT/AKYD
The following ASFC command data must be assigned at all nodes to be set BROKERAGE HOTLINE
service. SFI=36 (Brokerage Hotline), RES=1 (allowed)
Page 90
Brokerage - Hotline
term
a line appearance of the Hotline station number.
1
Station Number
term
Type of D
(0/1)
Key Number (1-40)
Service Index
0: Key not used
1: Feature Key
2: Multi-line Key
0
Ringing Assignment per Multi-Line Appearance
0: No Ringing
1: Ringing in Day Mode Only
2: Ringing in Night Mode Only
3: Ringing Day and Night
Single Line
TEC: 14
Assign as STN and
CON STN in AHLS
Hotline
term
D
Assign Subline as
Virtual: TEC 18
Assign as STN and
CON STN in AHLS
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
