Table of Contents
Advertisement
Interactions (cont'd)
2.
See TRUNK-TO-TRUNK CONNECTION
transferred off network.
3.
If a station is in an established THREE-WAY CALLING [T-2] connection, that station cannot activate
any features. If a station switch hook flashes to activate a feature, the flash is ignored and the three-way
connection remains established.
4.
Features that cannot be activated if a party is involved in a CONSULTATION HOLD [C-17, 17D] or in
an established THREE-WAY CONFERENCE [T-2] connection are:
ATTENDANT CAMP-ON WITH TONE INDICATION
ATTENDANT OVERRIDE
BOSS-SECRETARY OVERRIDE - D
BUSY VERIFICATION
CALL BACK
CALL FORWARDING (Activate or Cancel)
CALL PICKUP-DIRECT
CALL WAITING - TERMINATING
EXECUTIVE RIGHT-OF-WAY
MESSAGE REMINDER
OUTGOING TRUNK QUEUING Cancel
SPEED CALLING-STATION Entry
TRUNK ANSWER FROM ANY STATION (TAS)
5.
Upon establishing a CONSULTATION HOLD [C-17, 17D] connection and dialing a third party, if the
station user receives Busy or reorder tone instead of ringback tone, the station user flashes once to
disconnect the tone and reconnect the second party.
6.
Upon
establishing
MISCELLANEOUS TRUNK ACCESS [M-2] code, if no dial tone is heard (after the trunk is seized), if
a mistake is made in dialing, or if an intercept announcement or a permanent tone is heard, the station user
must go on-hook and wait for ringback tone.
7.
The station user, who establishes CONSULTATION HOLD [C-17, 17D], will be reconnected to the party
in soft hold when the third party disconnects.
8.
A call transfer to a station with CALL FORWARDING [C-2, 3, 5] set will forward according to the
conditions of the feature set.
9.
A call transfer to a station in a STATION HUNTING [S-7, 8, 9] group will hunt according to the
conditions of the STATION HUNTING [S-7, 8, 9] group.
10.
A call transfer to a D
11.
A call transfer call may be answered by CALL PICKUP-GROUP/DIRECT [C-7, 30].
12.
The Camp-on by Station is not available when the DO NOT DISTURB - D
the target station.
13.
The Camp-on by Station is not available when the target station uses PRIVACY RELEASE [P-18].
The operating station hears busy tone when the destination is in the above condition.
Note:
14.
When the Camp-on by Station is set by automatic operation and the destination station is the UCD group
member, the Camp-on by Station feature takes priority over BLIND TRANSFER TO BUSY UCD if it is
available.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Transfer - All Calls
a CONSULTATION
term
that has DO NOT DISTURB [D-21D] set will receive reorder tone.
Note
[T-10]
for additional programming if the call is to be
term
HOLD
[C-17,
17D]
[A-1]
[A-7]
[B-5D]
[B-3]
[C-1]
[C-2, 3, 5]
[C-30]
[C-12]
[E-1, E-1D]
[M-19D]
[O-2]
[S-21]
[T-8]
connection
and
dialing
term
[D-11D] has been set to
C-11
a
Note
Page 163
Advertisement
Table of Contents
