Table of Contents
Advertisement
L-11
L-11
General Description
This feature allows the Attendant to deny a preselected group of stations the ability to originate calls by activating
a key. The sole intention of this feature is to temporarily restrict the least important internal stations from outward
calling during an excessive traffic load or emergency conditions.
Operating Procedure
To activate from the ATTENDANT CONSOLE [A-3]
1.
Press a loop key.
2.
Dial the LINE LOAD CONTROL access code; receive service set tone.
3.
Press the RELEASE key.
To cancel from the ATTENDANT CONSOLE [A-3]
1.
Press the loop key.
2.
Dial the LINE LOAD CONTROL cancel code; receive service set tone.
3.
Press the RELEASE key.
Service Conditions
1.
This feature is controlled entirely from the ATTENDANT CONSOLE [A-3].
2.
Individual stations are programmed for this feature via CLASS OF SERVICE - INDIVIDUAL [C-15].
3.
The lamp on the ATTENDANT CONSOLE [A-3] will illuminate when LINE LOAD CONTROL is set
in the system.
4.
Incoming call from a trunk can be restricted in system data.
5.
When LINE LOAD CONTROL is activated or cancelled, a system message will be output via the
MAINTENANCE ADMINISTRATION TERMINAL [M-18].
6.
While LINE LOAD CONTROL is activated, a single line station will receive busy tone (or the display for
term
the D
is blank) when going off-hook.
7.
A station in LINE LOAD CONTROL [L-11, 20, 21] can receive incoming calls.
8.
Incoming calls terminated via CCIS/ISDN trunks are not restricted.
Interactions
1.
Calls in progress are not affected when this feature is activated.
2.
This feature is implemented on a per-system basis.
3.
Only the Attendant Console can activate this feature by seizing a loop and dialing the feature access code.
A designated key cannot be assigned at the Attendant Console to control this feature.
4.
Access to the system data via the Maintenance Administration Terminal (MAT) is allowed while LINE
LOAD CONTROL is active.
5.
Station-to-station calling to affected stations is not allowed during LINE LOAD CONTROL.
6.
HOTLINE [H-1] and HOUSE PHONE [H-2] connections become inoperative during LINE LOAD
CONTROL.
Page 446
Line Load Control
Line Load Control
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
