Procedures for Dual Cabinet Controller
Following procedure details how to install the harness, cooling - Axis 1 and 2 kit in the Dual
Cabinet Controller.
3HAC021313-001 Revision: K
Action
1.
DANGER!
Before any work inside the cabinet, please observe
the safety information in section
sure that the main power has been switched off! on
page
28.
2.
esd
WARNING!
The unit is sensitive to ESD, before handling the unit
please observe the safety information in section
WARNING - The unit is sensitive to ESD! on page
29
3. Remove the cover plate to an empty slot on the
connection plate.
4. Route the harness through the empty slot.
5. Fit the cover with cable gland.
6. Route the harness according to the illustration in
Locations in Dual Cabinet Controller on page 139
2 Installation and Commissioning, IRC5
2.9.9. Installation of cooling fan harness axis 1 and 2
Note/Illustration
DANGER - Make
xx0500002688
See
Controller on page
See
Controller on page
Continued
•
A: Sealing plug
•
B: Cover plate with gasket
Locations in Dual Cabinet
139.
Locations in Dual Cabinet
139.
Continues on next page
141