Replacing A 2-Axis Fdd Module (9/18 A) With A 2-Axis Fdd Module (18/36 A) (As From Sw3) - Siemens SINUMERIK 840C Installation Instructions Manual

Hide thumbs Also See for SINUMERIK 840C:

Table of Contents

5 Machine Data Dialog (MDD – as from SW 3)

5.9.4 Replacing a 2-axis FDD module (9/18 A) with a 2-axis FDD module (18/36 A) (as from SW3)

Specifications

Entering the

drive configuration

Motor selection

More user manuals on

Replacing a 2-axis FDD module (9/18 A) with a 2-axis FDD module

(18/36 A) (as from SW3)

A 2-axis FDD module (9/18 A) is to be replaced by a 2-axis FDD module (18/36

A) with a higher current rating.

Module slots:

(Installation loc.)

Delete the slot for the 2-axis FDD modules with the Delete slot softkey.

Confirm this setting with softkey Accept Conf + NCKP0.

Now enter the actual 2 axis FDD module (18/36 A) for the correct slot using soft-

key Select module. Again, confirm this setting with the Accept Conf + NCKP0

Select the current motors with the Enter motor softkey. Confirm the settings with

the Accept Conf + NCKP0 softkey.

Please make sure that you enter NC MD 3840 and 2000 correctly (assign).

The drive numbers of drives already installed must not be changed, i.e. a new

drive must be given a new drive number.

ManualsBase.com

1-axis FDD module

2-axis FDD module

SINUMERIK 840C (IA)

Simodrive 611-d