Siemens SINUMERIK 840C Installation Instructions Manual page 260

09.95
Notes
• Machine data 458* is taken into account only when a HMS servo loop module is used.
This MD also has an effect when the measuring system of the digital drive (611-D) is used.
• The multiplication factor must be taken into account for variable increment weighting
(MD 455*, 456*).
459*
Using zero mark offset, the spindle angle zero position (e.g. after M19 S0) can be made to
differ from the encoder zero mark. The spindle zero position can thus be defined arbitrarily.
In other words, the reference system for the spindle control is offset in relation to the encoder
reference system.
Note
• Changes to MD 459* do not take effect until the spindle is resynchronized with the
encoder.
• When specifying a positive value in MD 459*, the spindle angle zero position is offset in
the direction which corresponds to clockwise rotation (M03).
• If a C axis is assigned to the spindle, axis MD 244* takes effect in C axis mode as soon as
the C axis has been referenced.
Example
MD 4590 = 9 000
M19 S270 L F
(see MD 463* for further examples)
460*
Default value
MD 460* defines the assignment of the analog setpoint speed to a servo loop module and an
output.
_______
1) See also Section C axis mode
2) As from SW 4
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Default value Lower input limit
-99 999 999
0
-18 000
Zero mark offset by 90 degrees
The spindle is positioned to 270° in the control reference system.
As this reference system is offset from the encoder zero mark by
90 degrees, the spindle will thus be on the encoder zero mark.
Lower input limit
0 0
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Zero mark offset
Upper input limit
99 999 999
2)
18 000
1)
Setpoint output (analog)
Upper input limit
See permissible values
6FC5197- AA50
6.5 Spindle-specific MD (spindle data)
Active on
Power On
Units
0.01°
2)
Active on
Power On
Units
–
6–75