Siemens SINUMERIK 840C Installation Instructions Manual page 963

12 Functional Descriptions
12.19.4 Temperature compensation TC
The effects of both errors are cumulative and mutually superimposed so that the approximation
with regards to actual value influence is as follows:
-x
Please note the following definitions:
K :
TC
K :
TCabs
P :
x
P :
0
tanß :
Caution:
Reference point P
The approximated error line of the axis is now used by the control for temperature
compensation of this axis.
Since the error line applies only to the current temperature value, the parameters of new error
lines occurring as a result of increases or drops in temperature must be transferred to the NC
again.
Only in this way can it be ensured that varying degrees of thermal expansion are compensated
in the correct way.
12–188
More user manuals on
Error
(comp. value)
0
P
Temperature compensation value for axis i at position P
Position-independent TC value for axis i
Actual position of axis i
Reference position for axis i
Coefficient for position-dependent TC
(depends on temperature and coefficient of linear expansion of machine).
K - K
TC TCabs
tanß = ––––––––––––––
P - P
x 0
must not coincide with the axis zero point.
0
ManualsBase.com
Error curve
ß K
TC
K
TCabs
Reference
P
x
point
0
© Siemens AG 1992 All Rights Reserved
09.95
Approximated
error line
+x
x
6FC5197- AA50
SINUMERIK 840C (IA)