Siemens SINUMERIK 840C Installation Instructions Manual page 664

Hide thumbs Also See for SINUMERIK 840C:
Table of Contents

Advertisement

09.95
Note
Data output of
circularity test
measurement results
Note
Display
Explanation
Note
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
More user manuals on
The displayed measurement results can be stored as a file on the MMC by selecting
softkey File functions.
Data can be output on an external PC via the V24 interface and
by means of commands in the "Services" menu. The extensions for "Services"
required for this purpose are listed in the requirements to other areas. Data can
therefore be output in PC format with the aid of the "PC-IN" program. Within this
program, it is possible to re-convert the data back to the original ASCII format
with software version 3.0 and higher.
Measurement results can also be written to a file using the hardcopy function and
output by means of "Services" functions.
SW 5
You can switch to graphic representation of the contour with this softkey.
Fig. 9.19
The contour is shown without any distortion if the value 0 is entered in the field
"Resolution". If suitable radius and feedrate values are entered, other contours
can also be displayed.
Radius and feedrate represent the input parameters required for setting the mea-
suring duration and the radius is used to define the form of graphic representa-
tion.
Storage and output of the measuring results are the same as described for the
circularity test display in Section 9.5.2.
ManualsBase.com
9 Drive Servo Start-Up Application (as from SW 3)
9.5.2 Circularity test (option – SW 4)
9–43

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611-d

Table of Contents